Wooden Home Furniture
All designs

Wardrobe Design with Mirror: Shutter, Sliding and Almirah Ideas

16 designs Wardrobes and almirahs Checked 9 Oct 2026

A wardrobe design with mirror gives you a full length dressing mirror without giving up any floor. In a small Indian bedroom that often means you can skip a separate dresser and keep 2 ft more walking space. A mirror also bounces window light deeper into the room.

The 16 designs below cover full mirror shutters, slim strips, sliding mirror fronts, almirahs and tinted mirrors. Each card lists the board, size and room it suits. Ask your carpenter for 5 mm mirror, a firm backing board and safety film on every mirror door, and read the tips below the gallery before you order. If you are planning a wardrobe design for bedroom with mirror and a sitting counter together, see wardrobe with dressing table.

Wardrobe Design with Mirror: Full Length Shutters

One full height mirror door is the most useful wardrobe with mirror design. Put it on the shutter where daylight falls on you, not behind you, and give it four hinges because it is heavier than a plain door.

3 door wardrobe design with mirror on the right end shutter and oak veneer doors

The mirror sits on the end door next to the window, so light falls on your face while you dress. Two oak veneer doors keep the rest calm.

  • MaterialBWR ply, oak veneer
  • Size6 ft x 7 ft, 3 door
  • Fits10 x 11 ft bedroom

Carpenter tip: Hinge the mirror door on the wall side so it opens away from the window light.

Simple wardrobe design with mirror on the left door of an ivory PU 2 door unit

A plain ivory 2 door wardrobe with one full mirror door is the easiest upgrade for a rented or first flat. Thin brass edging stops the mirror corners from chipping.

  • MaterialMDF, ivory PU, mirror
  • Size4 ft x 7 ft, 2 door
  • Fits9 x 10 ft bedroom

Carpenter tip: Fix a 5 mm brass L angle around the mirror, it guards the edge when clothes brush past.

Modern wardrobe design with mirror on two centre doors of a charcoal 4 door unit

Two mirror doors in the middle of a charcoal unit work like one wide dressing mirror for a couple. The dark outer doors frame them neatly.

  • MaterialBWR ply, charcoal matte
  • Size8 ft x 7 ft, 4 door
  • FitsMaster bedroom

Carpenter tip: Keep both mirror doors the same width and level, even a 2 mm step shows in the reflection.

Bedroom wardrobe design with mirror shutter and a matching loft for a high ceiling

On a 10 ft ceiling the mirror door stops at 7 ft and a plain loft above holds bedding and suitcases. Teak laminate keeps it warm next to the mirror.

  • MaterialBWR ply, teak laminate
  • Size6 ft x 7 ft + 3 ft loft
  • FitsOld house, 10 ft ceiling

Carpenter tip: Never put mirror on loft doors, you need a stool to reach them and the risk of a knock is high.

Mirror Strip and Inset Wardrobe Mirror Design

If you do not want a full mirror facing the bed, a strip, band or inset panel gives you a quick check mirror and some sparkle. Inset mirrors sit in a routed recess so the edges stay protected.

Wardrobe mirror design with a horizontal mirror band across sand beige shutters

A 12 in mirror band runs across all three doors at face height, like a long dressing strip. It suits people who only need to check hair and face.

  • MaterialBWR ply, sand laminate
  • Size6 ft x 7 ft, 3 door
  • Fits10 x 12 ft bedroom

Carpenter tip: Mark the band height with the tallest person in the house standing in front of it.

Mirror wardrobe design with arched inset mirrors in sage green PU shutters

Each sage door carries a tall arched mirror set into a routed recess. The arch softens a boxy unit and looks right in a calm, earthy room.

  • MaterialHDF, sage PU, mirror
  • Size4.5 ft x 7 ft, 2 door
  • FitsGuest bedroom

Carpenter tip: Cut the mirror arch from a paper template of the routed recess, not from the drawing.

Wooden wardrobe design with mirror panes in a grid set into a walnut veneer door

Small square mirror panes inside a walnut veneer grid look like a window frame. If one pane cracks, only that piece needs to be replaced.

  • MaterialWalnut veneer, mirror
  • Size6 ft x 7 ft, 3 door
  • Fits12 x 12 ft bedroom

Carpenter tip: Use 4 mm mirror for small panes and fix each one with beading so it can come out later.

Sliding Mirror Wardrobe Design

Sliding mirror fronts suit rooms where a hinged door would hit the bed. The carcass has to be about 2 in deeper than a hinged unit so the track fits, and pick framed mirror shutters so the edges never rub each other.

Sliding mirror wardrobe design with each shutter split into mirror and teak veneer halves

Each sliding shutter is half mirror and half teak veneer, split down the middle. Whichever way you slide, there is always some mirror in view.

  • MaterialBWR ply, teak veneer
  • Size8 ft x 7.5 ft, 2 slide
  • Fits11 x 12 ft bedroom

Carpenter tip: Use a top-hung track rated for the weight, mirror halves make each shutter much heavier.

Modern sliding wardrobe with grey mirror bands between white laminate panels

Each shutter has three horizontal bands with a grey mirror between two white panels. The tint reflects softly, so the room does not feel watched.

  • MaterialBWR ply, white, grey
  • Size7 ft x 7.5 ft, 2 slide
  • Fits10 x 10 ft bedroom

Carpenter tip: Order shutters from one profile maker so the band lines meet when both doors close.

L shape wardrobe design with mirror sliding doors on the long arm of the corner

The long arm of an L shaped wardrobe gets two mirror sliders, while the short arm has plain hinged doors. It turns an awkward corner into a dressing area.

  • MaterialBWR ply, ash laminate
  • Size8 ft + 5 ft, L shape
  • FitsMaster bedroom corner

Carpenter tip: Keep the corner as a blind shelf and start the sliders 24 in from it so they clear the turn.

Almirah Design with Mirror

A mirror almirah design suits freestanding pieces, niche almirahs and small rooms that need a single tall unit. In solid wood, the mirror is fixed from the back in a rebate so the front frame stays clean.

Almirah design for bedroom with mirror on the centre door, teak with a cornice top

A teak almirah with a moulded cornice and one mirror door in the centre has a classic almirah mirror design. A drawer in the plinth keeps documents handy.

  • MaterialTeak, honey polish
  • Size4.5 ft x 7 ft, 3 door
  • FitsParents' bedroom

Carpenter tip: Back the mirror with 6 mm ply screwed into the rebate, so it cannot fall out when the door slams.

Wall almirah design with mirror shutters and open shelves in a cement niche

A cement niche gets two mirror shutters on the sides and open shelves in the middle for daily things. It needs very little depth and no floor space.

  • MaterialBWP ply, white laminate
  • Size5 ft x 7 ft, 18 in deep
  • FitsNiche in bedroom wall

Carpenter tip: Fix BWP ply against the cement back of the recess, keeping a 10 mm air gap from damp plaster.

Mirror almirah design with one mango wood door and a rounded corner mirror

A slim single door almirah with a rounded corner mirror fits beside a bed or behind a door. Good for a hostel room, small flat or study.

  • MaterialMango wood, matte polish
  • Size2 ft x 6 ft, 1 door
  • FitsSmall room or studio

Carpenter tip: Screw a tall single door almirah to the wall with an L bracket so it never tips forward.

Tinted, Bronze and Antique Mirror Wardrobes

Tinted mirrors give a softer, darker reflection that looks rich in the evening. Bronze suits wood tones, grey suits white and black rooms, and antique mirror suits old style homes.

Wardrobe design for bedroom with mirror in bronze tint and walnut veneer doors

Two bronze mirror doors sit between walnut veneer doors with a warm light strip above. The bronze tint blends with the wood instead of shining hard.

  • MaterialWalnut veneer, bronze
  • Size8 ft x 7 ft, 4 door
  • Fits13 x 14 ft bedroom

Carpenter tip: Run the light strip in an aluminium channel above the doors, never behind the mirror backing.

Wardrobe with mirror design in grey tint across three handleless doors and white frame

All three doors are grey tinted mirror with a slim groove for a pull, set inside a white gloss frame. It reads as one dark smooth wall in a modern room.

  • MaterialBWR ply, grey mirror
  • Size6 ft x 7 ft, 3 door
  • FitsModern flat bedroom

Carpenter tip: Use push-to-open latches with soft-close hinges, so nobody presses fingers on the mirror.

Wooden almirah with antique mirror panels in a sheesham frame for a heritage bedroom

Antique mirror has a soft, cloudy finish that looks aged and hides smudges. Set in dark sheesham frames, it suits a home with old style furniture.

  • MaterialSheesham, antique mirror
  • Size4 ft x 7 ft, 2 door
  • FitsHeritage style bedroom

Carpenter tip: Season sheesham well before framing mirror, a frame that twists later will crack the panel.

Backing, Safety Film and Fixing: What to Tell Your Carpenter

  • Thickness: 5 mm mirror for full doors. Thinner mirror bends and shows a wavy reflection.
  • Backing: stick the mirror on a flat 12 mm BWR ply or HDF shutter with neutral silicone made for mirrors. Acid based silicone eats the silver and leaves black spots.
  • Safety film: ask for film on the back of every mirror. If it cracks, the pieces stay stuck instead of falling.
  • Edges: polished or bevelled edges, or an aluminium or brass frame, so nothing sharp is exposed.
  • Hinges: four soft-close hinges on a 7 ft mirror door, and a top-hung heavy duty track for sliders.

For the inside layout behind these doors, see wardrobe inside design. For glass, cane and panel shutters without mirror, see wardrobe door design.

Care in Monsoon and Placement Tips

Damp air can creep behind the mirror and spoil the silver at the edges. Keep mirror wardrobes 2 to 3 in away from outer walls that get wet, and never fit them on a bathroom wall. Clean with a soft dry cloth. Dampen the cloth with cleaner first rather than spraying the glass, because drips that reach the edges seep behind the silver.

Many families prefer that a mirror does not face the bed directly. If your room allows only that wall, use a strip, a tint or a side shutter mirror. For tight rooms, also look at small wardrobe design.

Questions people ask

Which door is best for the mirror in a 3 door wardrobe design with mirror?

Choose the door that faces the window, so daylight falls on you while you dress. The centre door is common, but an end door is easier to reach in a tight room. Give the mirror door four hinges.

How thick should a wardrobe mirror be?

Use 5 mm mirror for a full length door and 4 mm only for small panes. Stick it on a flat ply or HDF backing with neutral silicone and add safety film on the back.

Is a mirror almirah safe in a home with small kids?

Yes, if the mirror has safety film on the back and polished edges or a frame. Fix tall freestanding almirahs to the wall so they cannot tip. Keep the mirror higher or use a strip if kids play near the unit.

Can I add a mirror to my old wooden almirah?

Yes. A carpenter can rout a shallow recess on one door and set a 5 mm mirror inside with beading, or stick a framed mirror on a flat door. Check the hinges first, because the door will become heavier.

Should I choose tinted or clear mirror for a modern wardrobe design with mirror?

Clear mirror shows true colours and is best for dressing. Grey or bronze tint looks softer and suits a modern room, but use it as a second mirror, not the only one you dress in front of.

Why do black spots appear on wardrobe mirrors?

Black spots come when damp or acid based glue reaches the silver layer at the back. Use neutral silicone, seal the edges and keep the wardrobe away from wet walls and bathroom walls.

Keep browsing